共找到 150 條與 專用水文測站 相關的標準，共 10 頁
Closures for groundwater measuring stations
The American National Standards Institute (ANSI) has adopted X3.145- 1986 which similarly specifies U. S. Geological Survey Circular 878
CODES FOR THE IDENTIFICATION OF HYDROLOGIC UNITS IN THE UNITED STATES AND THE CARIBBEAN OUTLYING AREAS
Hydrometry. Selection, establishment and operation of a gauging station
Railway applications. Service stations. Drainage equipment for wastewater tanks.
This paper describes typical water conservation measures employed at steam electric-generating stations; a typical zero-discharge water management
Water Usage Trends in Steam Electric Generating Stations
Diese Internationale Norm legt Anforderungen an Ausrustung, Verankerung, Masten und Zubehorteile fur Seilkrananlagen fest, die fur Messungen
Hydrometry - Cableway systems for stream gauging (ISO 4375:2014)
本標準規定了水電站壓力鋼管用鋼板的牌號表示方法、訂貨內容、尺寸、外形、重量及允許偏差、技術要求、試驗方法、檢驗規則、包裝、標志及質量證明書等。 本標準適用于厚度12 mm~150 mm的水電站壓力鋼管、蝸殼、岔管用鋼板（以下簡稱“鋼板
Steel plates for steel penstock in hydropower station
This International Standard defines the requirements for equipment, anchorage, supports and accessories for cableway systems for use in stream
Hydrometric determinations - Cableway system for stream gauging
This International Standard defines the requirements for equipment, anchorage, supports and accessories for cableway systems for use in stream
Hydrometry - Cableway systems for stream gauging
Hydrometric determinations - Cableway systems for stream gauging.
Horizontal pressure tanks for air pressure generating stations in electrical switching plants
1 Scope 1.1 Object This Standard provides Canadian monitoring network operator requirements and recommendations for selecting sites for automated
Automated hydrometeorological monitoring stations: Site selection, instrument installation, and instrument maintenance
本標準規定了泵站用水箱支架的型式與尺寸。 本標準適用于泵站用水箱支架。 本標準與JB/T 2001.66-1999 中規定的水箱配套使用
Water system.Water tank support for water accumulator.Type and size
Draft Document - Codes of practice for drinking water installations - Part 500: Pressure boosting stations with RPM-regulated pumps
本標準規定了球形蓄勢器水罐的型式、尺寸及技術要求。 本標準適用于公稱壓力為20MPa、以水和空氣為介質的泵站用球形蓄勢器水罐
Water system.Water ball-accumulator
