共找到 150 條與 洗液殘留度 相關的標準，共 10 頁
Testing of pigments; determination of residue on sieve with water as washing liquid (hand method)
本標準規定了洗滌用品堿性殘留的測定方法
Determination of alkalinity residue of detergents
This Standard method covers the qualitative determination of the acidity of hydrocarbon liquids and their distillation residues. To determine
Liquid hydrocarbons and distillation residues - Qualitative Determination of acidity or basicity
本標準規定了洗碗機洗滌系統洗滌有害殘留的技術要求和試驗方法。 本標準適用于單相額定電壓不超過250 V 的家用和類似用途電動洗碗機
Technical requirements and test methods for washing harmful residues in washing system of dishwashers
本標準規定了微陣列生物芯片清洗儀器(以下簡稱清洗儀)的術語和定義、要求、試驗方法、檢驗規則、標志、標簽和使用說明書、包裝、運輸和貯存。 本標準適用于微陣列生物芯片清洗儀
Technical requirement of microarray washer
Liquefied petroleum gases. Determination of residue
警告：使用本標準的人員應有正規實驗室工作的實踐經驗。本標準并未指出所有可能的安全問題。使用者有責任采取適當?shù)陌踩徒】荡胧?，并保證符合國家有關規定條件。 本標準規定了采用頂空進樣氣相色譜-電子俘獲檢測器(GC/ECD)測定紡織品干洗后四氯乙烯殘留量的方法。 本標準適用于各類紡織制品
Textiles.Determination of the tetrachloroethylene residues after dry cleaned
本標準適用于液化石油氣在38℃揮發后殘留物含量的測定。 注：本方法用于測定含醇液化石油氣時會有誤差。液化石油氣加入醇類物質，是為了提高其抗凍性
Determination of LPG residues
本標準規定液化石油氣在38℃以上溫度風化下所遺留的殘留物質含量之試驗法
Method of test for residues in liquefied petroleum (LP) gases
1.1 This test method covers the detection of a residual odor in drycleaning-grade perchloroethylene. 1.2 This standard does not purport
Standard Test Method for Detecting Residual Odor of Drycleaning Grade Perchloroethylene
This test method covers the detection of a residual odor in drycleaning-grade perchloroethylene. This standard does not purport to address all
Test Method for Detecting Residual Odor of Drycleaning Grade Perchloroethylene
This method describes a procedure for determining extraneous materials weathering above 38°C which are present in liquefied petroleum gases (LPG
Residues in Liquefied Petroleum Gas [P:70]
This poster paper outlines the City of Markham, Ontario, Canada's flushing program, providing the four steps of the program, the flushing procedure
Dead-end Flushing for Chlorine Residual Maintenance and Regulatory Compliance
1.1 This test method covers the determination of moisture and residue in liquid chlorine. Lower limits of detection of 10 μg/g based on a 150-mL
Standard Test Method for Moisture and Residue in Liquid Chlorine
test method for liquefied petroleum gas residues
