共找到 150 條與 涂包二氧化鈾微球 相關的標準，共 10 頁
This International Standard describes a method for the measurement of the local thickness of metallic coatings, oxide layers, and porcelain
Metallic and oxide coatings -- Measurement of coating thickness -- Microscopical method
Metallic and oxide coating－Measurement of coating thickness－Microscopical method
Two Components High Build Epoxy Titanium Dioxide ( TiO2 ) Pigmented Intermediate Coat a€” Specification
本標準規定了電子及電器工業用硅微粉的分類，技術要求，試驗方法，檢驗規則及包裝、標志、運輸、貯存。 本標準適用于電子及電器工業中環氧樹脂澆注料、灌封料、塑封料、模塑料、工程塑辯、涂料(含粉未涂料和液態涂料)以及電焊條保護涂層等用硅微粉
Silicon dioxide micropowder for electronic and electrical equipment industry
Metallic and oxide coatings – Measurement of coating thickness – Microscopical method
Destructive method. Includes accuracy requirement, factors relating to the measuring accuracy, preparation of cross-section and procedure
Metallic and oxide coatings. Measurement of coating thickness. Microscopical method
Silica fume for unshaped refractory
Metallic and oxide coating－Measurement of coating thickness－Microscopical method
本標準規定了不定形耐火材料用二氧化硅微粉的牌號、技術要求、試驗方法、檢驗規則、包裝、標志、貯存、運輸和質量證明書。 本標準適用于冶煉鐵合金或工業硅時，通過煙罩收集的含硅煙氣，氧化凝聚后經干式收塵裝置收集的二氧化硅微粉
Silica fume for unshaped refractory
Specification for zinc oxide for paints Second Revision
METHODS OF TESTING TITANIUM DIOXIDE PIGMENTS FOR PAINTS
1.1 This specification covers finished sintered and ground (U, Pu)O2 pellets for use in light water reactors. It applies to (U, Pu)O2 pellets
Standard Specification for Sintered (Uranium-Plutonium) Dioxide Pellets for Light Water Reactors (Standard + Redline PDF Bundle)
Silicon dioxide micropowder for electronic and electrical equipment industry
This International Standard describes the ceramographic preparation of uranium dioxide (UO2) sintered pellets for qualitative and quantitative
Nuclear fuel technology -- Guide for ceramographic preparation of UO2 sintered pellets for microstructure examination
This International Standard specifies a non-destructive method for determining the thickness of anodic oxidation coatings on aluminium and its alloys
Anodizing of aluminium and its alloys -- Determination of thickness of anodic oxidation coatings -- Non-destructive measurement by split-beam microscope
