共找到 150 條與 X射線管電壓 相關的標準，共 10 頁
Measuring devices for X－ray tube voltage
Measuring devices for X－ray tube voltage
Measuring devices for X－ray tube voltage
X-ray devices. The methods of measuring of the voltage of X-ray tube
This standard specifies the test method for a non-invasive measurement of X-ray tube voltages using the energy spectrum of X-rays (spectrometric
Non-destructive testing - Measurement and evaluation of the X-ray tube voltage - Spectrometric method
Non-destructive testing - Measurement and evaluation of the X-ray tube voltage - Spectrometric method
本部分的ISO 16526規定了對X射線系統高壓側二次方測量平均高電壓直接絕對測量方法。該方法用于檢查X射線系統控制單元所示高壓值的一致性。為了保證操作的可重復性，這種辦法特別適用于檢測材料穿透和對比度的影響，并且還要符合輻射保護要求
Non-destructive testing. Measurement and evaluation of the X-ray tube voltage. Voltage divider method
Non-destructive testing - Measurement and evaluation of the X-ray tube voltage - Voltage divider method
This European Standard specifies a method for the direct and absolute measurement of the average high voltage of constant potential (DC) X-ray systems
Non-destructive testing - Measurement and evaluation of the X-ray tube voltage - Voltage divider method
本文件規定了直接和絕對地測量X射線系統高壓發生器次級側恒定電位(DC)平均高壓的方法,確立了檢查高壓輸出與X射線系統控制單元上管電壓示值的對應關系。 本文件適用于確保X射線系統的可重復性操作,管電壓影響材料的穿透性能和X射線圖像的對比度,同時影響輻射防護有關要求
Non-destructive testing—Measurement and evaluation of the X-ray tube voltage—Part 1: Voltage divider method
本文件規定了使用X射線能譜對X射線管電壓進行測量的方法(能譜測定法)。測量電壓范圍為10kV~500kV。 本文件規定的方法檢查實際電壓與X射線系統控制器顯示電壓的一致性,僅測量最大能量,而不是測量完整的X射線能譜。 本文件適用于高壓箱式和恒電位式X射線系統
Non-destructive testing—Measurement and evaluation of the X-ray tube voltage—Part 3:Spectrometric method
Non-destructive testing - Measurement and evaluation of the voltage of X-ray tubes - Part 3: spectrometric method
Non-destructive testing -- Measurement and evaluation of the X-ray tube voltage -- Part 3: Spectrometric method
This standard specifies the test method for a non-invasive measurement of X-ray tube voltages using the energy spectrum of X-rays (spectrometric
Non-destructive testing - Measurement and evaluation of the X-ray tube voltage - Part 3: Spectrometric method
ADOPTED_FROM:EN 12544-3:1999 This standard specifies the test method for a non-invasive measurement of X-ray tube voltages using the energy spectrum
Non-destructive testing — Measurement and evaluation of the X-ray tube voltage — Part 3: Spectrometric method
