AS 3580.6.1:2023
環境空氣采樣和分析方法 方法6.1：臭氧的測定 直讀儀器法
Methods for sampling and analysis of ambient air, Method 6.1: Determination of ozone — Direct-reading instrumental method
- 標準號
- AS 3580.6.1:2023
- 發布
- 2023年
- 總頁數
- 30頁
- 發布單位
- 澳大利亞標準協會
- 當前最新
- AS 3580.6.1:2023
- 引用標準
- AS 3580.19 AS/NZS 3580.1.1
- 適用范圍
- AS 3580.6.1:2023 規定了使用直讀儀器測定環境空氣中臭氧的方法。該方法適用于測定環境空氣中標稱濃度范圍為 0 至 0.5 ppm（體積比）（0 至 1 071 μg/m3，0 °C 和 101.3 kPa）的臭氧。如果需要，現代儀器可以在更大的范圍內進行測量
| 術語 | 描述 |
|---|---|
| 下降時間 fall time | Time interval, after a step decrease in input concentration, between initial instrument response and 95 % of final instrument response. |
| 全量程 full scale | Nominated maximum concentration for which an instrument has been calibrated. |
| 干擾等效 interference equivalent | Positive or negative instrument response caused by a substance other than the one being measured. |
| 滯后時間 lag time | Time interval between a step change in input concentration and the first observable corresponding change in instrument response. |
| 一級校準 level 1 calibration | Two-point instrument calibration using a reference test atmosphere which includes adjustment of instrument gain or zero. |
AS 3580.6.1:2023 中提到的儀器設備
| 連續直接讀數儀器 Not specified | A continuous direct-reading instrument is required, which shall meet or exceed the specifications given in Table 1. The instrument may be used over any range within the limits of this document. |